Weiheng

The Teleport can connect to Weiheng Tianwu battery system using Modbus TCP over ethernet. Teleport can manage the following mode(s) of operation:

• Real Power Dispatch

Note

We support Weiheng Tianwu battery systems with EMS Software Version v2.4.1 and above and Protocol Version 2.

Configuration

Note

Please inform us of the chosen Slave ID, IP address and Subnet Mask as configured on the asset and the router.

Connecting via a router (recommended)

Connect an Ethernet cable between the router and the WAN port (or CON1 port) of the TP Link router inside the Tianwu battery system, as well as between the ETH1 port of the Teleport and the router. Navigate to our appendix for generic instructions on how to integrate with a router. Make sure to note the IP of Teleport and the IP of the asset(s).

Connecting the Battery Directly to the Teleport

1. Connect the ethernet cable between the ETH1 port of the Teleport and the WAN port (or CON1 port) of the TP Link router inside the Tianwu battery system.
2. Configure the following settings, with values as described in Static IPs for a direct asset connection.
   • IP address
   • Subnet mask