Skip to content
Teleport

Dyness

The Teleport can connect to the Dyness products included in the list of supported models below.

Supported models
  • DH200F
  • DH100F
  • DH200Y

Supported & Unsupported properties details

Properties

Supported properties

  • frequency
  • activePower
  • reactivePower
  • powerFactor
  • availableActivePower.charge
  • availableActivePower.discharge
  • stateOfCharge
  • stateOfHealth
  • batteryStatus
  • energy.charged
  • energy.discharged
  • acCurrentMediumVoltage.phase.l1
  • acCurrentMediumVoltage.phase.l2
  • acCurrentMediumVoltage.phase.l3
  • acVoltageMediumVoltage.line.l1
  • acVoltageMediumVoltage.line.l2
  • acVoltageMediumVoltage.line.l3
  • acVoltageMediumVoltage.phase.l1
  • acVoltageMediumVoltage.phase.l2
  • acVoltageMediumVoltage.phase.l3
  • batteryEnergyStorageSystems[]
  • batteryEnergyStorageSystems[].stateOfCharge
  • batteryEnergyStorageSystems[].cellTemperature.min
  • batteryEnergyStorageSystems[].cellTemperature.max
  • batteryEnergyStorageSystems[].roomTemperature

Unsupported properties

  • availableEnergy
  • ratedEnergy
  • availableReactivePower.inject
  • availableReactivePower.absorb
  • batteryEnergyStorageSystems[].availableEnergy
  • batteryEnergyStorageSystems[].availableActivePower.charge
  • batteryEnergyStorageSystems[].availableActivePower.discharge
  • batteryEnergyStorageSystems[].racks[]
Setpoint operations

The asset can be controlled via the Teleport to set the following operations.

  • dispatchPower - to control active power setpoint

Modbus configuration

The Teleport can connect to Dyness battery systems using Modbus RTU over RS485 or TCP over Ethernet connection.

Modbus TCP over ethernet

  1. Connect an Ethernet cable between the asset and either a router or an Ethernet port of the Teleport. If connected via a router, please navigate to our appendix for more instructions on how to integrate with a router.

  2. Go to Setting > EMS > SysSet > Network to configure the TCP network configuration.

  3. Refer to the Dyness EMS Quick Adaptation Manual - modbus protocol or similar, for more TCP configuration instructions.

Modbus RTU over RS485

  1. Connect the serial cable between the serial port of the Teleport and the serial port of the Dyness battery.

  2. Check that the default settings are:

    • Device address: 1
    • Data bits: 8
    • Stop bits: 1
    • Parity: None
    • Baud rate: 115200 bps

  3. Refer to the Dyness EMS Quick Adaptation Manual - modbus protocol or similar, for more configuration instructions.