Wago

Teleport can connect to Wago meters. You can connect using Modbus RTU using the RS485 serial interface.

Supported models

• 879-3000 4PU
• 879-3040 2PU CT
• 879-3020 4PS

Note

The Teleport is capable of reading reactive power measurements; however, the direction and magnitude have not yet been verified.

Modbus RTU over RS485

1. Connect the serial cable between the serial port of the Teleport and the serial port of the meter.
2. Teleport is configured to use the following Modbus interface configuration. Please configure the meter to use the same settings or let us know if you use a custom configuration:
   • Device address: 1
   • Baud rate: 9600
   • Stop bits: 1
   • Parity: none

Tip

• Better performance can be achieved by using a higher baud rate. Let us know if you configure a higher baud rate on your asset.